The prosize command

TUTORIAL

Prosize configures the executables to run with the exact parameters of your problem. For exempla you can modify the maximum number of boundaries in your problem or like in this case allow the existence of events like the sliding mesh.

This command should be used before starting a new case.
 

The prostar windows
Prostar is running on 3 main windows.

The graphical window displays results and enables the user to define what and how it should be displayed.

The graphic window setting

The command window is the place where you can type commands. It is an very important window as all the results of the commands (done graphically or by typing) are displayed here. The user should check after each step if there is an error message or if the result is correct.

The Star GUIde window regroups all the possible tools needed to build a mesh, set the boundaries, define the operating conditions, setup the computation.
 


DESCRIPTION

You have to use events and must modify the prosize to do so by changing the answer of 2 questions:

WILL YOU BE DOING A TRANSIENT WITH THE EVENT MODULE?
Yes

HOW MANY EVENTS WILL YOU NEED?
10